Dental scalers may occasionally encounter operational issues, but resolving these problems can be a straightforward process. Here is a concise guide to help you efficiently identify and address common problems without unnecessary details.
1. Dental Scaler Not Functioning Properly:
-
Check the Power Supply: Begin by verifying that the dental scaler has a properly functioning power supply.
-
Inspect the Relay (Foot Pedal) Coil: Examine the power supply coil for the relay (foot pedal).
-
Verify Relay Functionality: Ensure that the relay is securely connected and closed, and check for voltage output.
-
Tighten the Tooth Cleaning Head: If the tooth cleaning head has become loose due to extended use, power down the machine and use the provided wrench to secure it.
-
Adjust the Power Potentiometer: Check the setting on the power adjustment potentiometer; if it’s too low, adjust it clockwise.
-
Secure Loose Knobs: If any control knobs are loose, tighten them securely.
-
Replace the Solenoid Valve: In the event of solenoid valve damage, it should be replaced.
2. Troubleshooting Scaler Issues:
a. Insufficient Vibration During Teeth Cleaning:
- Steps: Ensure that the following components are checked – power connection plug, power switch, indicator light, tooth cleaning tip installation, foot pedal connection port, tooth cleaning power switch adjustment, and consider replacing the tooth cleaning handle.
b. No Water Flow After Teeth Cleaning:
- Steps: Examine the scaling tip installation, adjust the water regulating valve, verify the three-way scaler interface at the chair position, and check the water vapor switch valve at the chair position.
c. Water Output Adjustment Failure:
- Solution: Open the water regulating valve and adjust the internal regulating lever.
By following these concise steps, you can swiftly identify and resolve common issues with your dental scaler. Proper troubleshooting will ensure the efficient functioning of your equipment.
Lingchen Dental – Easy to Dentist.
Post time: Oct-19-2023